ClickBank1

My garage door will open using the remote opener but not close?

I can open the door using the remote opener but it will not close using it. I have to stand inside and use the wall panel to close the door and it will only do so if I hold it until it is completely shut–otherwise, it stops and when pressed again goes back up. Model is Overhead Door 1/2 HP #OCG750. Light on wall panel stays lit red. One of the sensors on floor (the one that I think shows green) is not lit.


2 Responses to “My garage door will open using the remote opener but not close?”

  1. pickmefirstplz says:

    one or more of the floor sensors are malfunction try cleaning the eye

  2. scarface says:

    check the infra red safety switch (led Light Beam) it might be off the reflector

Leave a Reply